Wiring A Light Bar Switch - Wiring Flow Schema

The task of wiring a light bar switch may seem daunting to some, but it can be a relatively straightforward process when done correctly. For those who are unfamiliar with the task, having a few tips and tricks up your sleeve can help the job go smoother and faster.

The first step in wiring a light bar switch is to ensure you have all of the necessary supplies on hand. Gather the light bar switch, a flathead screwdriver, a wire nut, electrical tape, and a few feet of insulated wire. Once you have all the tools, you will be ready to begin the wiring process.

The next step is to locate the positive and negative terminals on the switch. These are usually labeled “+” and “-”, respectively. Using the flathead screwdriver, loosen the screws holding the terminals in place and attach the positive terminal to one end of the wire and the negative terminal to the other end. Once the connections are secure, use electrical tape to protect them from the elements. Then, use the wire nut to connect the remaining two ends of the wire, which should now be securely connected to the switch.

Finally, it is important to test the light bar switch before turning it on. Make sure the switch is in an “off” position and then flip the switch to “on”. If the switch lights up, you have successfully wired the switch. If it does not, check that all connections are still secure and try again.

Wiring a light bar switch may seem intimidating, but following these tips can help you complete the job with speed and accuracy. With all of the necessary supplies and a bit of patience, anyone can successfully wire a light bar switch.

Jegs 79903 Led Light Bar Wiring Harness With Switch And Dual Plug High Performance